Quick Start

Preliminary documentation. This product is in pre-launch preview; specifications and commands may change before shipping.

Setup takes about 15 minutes. You will need a Phillips screwdriver.

1. Mount to the desk

1. Choose clamp (desk edge 10–80 mm thick) or grommet (through a cable hole).
2. Fit the mount to the bottom of the arm column and tighten it until the column does not rock.
3. Leave at least 250 mm of free space behind the column — the depth axis moves the screen forward and back.

2. Attach the monitor

1. Screw the VESA plate to the back of your monitor (75 or 100 mm pattern).
2. Slide the plate onto the quick-release bracket until it clicks.
3. Check the weight limit: 9 kg for Standard, 15 kg for Heavy-Duty.

3. Power and balance

1. Connect the 24 V adapter to the base. The ring on the sensor pod glows white.
2. Hold the base button for 3 seconds. The arm runs a balance check, moving slowly through its full height; this sets the motor current for your monitor.

4. First-time posture setup

1. Sit the way you normally work.
2. Press the base button once. The ring turns blue while the arm finds your eye line and a 60 cm viewing distance.
3. Adjust by hand if you prefer a different position — the arm learns your offset and keeps it while tracking.

Modes at a glance

Next steps

• Serial API — script positions from your computer.
• Troubleshooting — tracking and noise issues.